On Mon, 2005-02-07 at 12:46 +0000, Federico Calboli wrote:
> On Mon, 2005-02-07 at 13:35 +0100, Aldo Maggi wrote:
>
> > ma sei sicuro che quando lo reinserisci la macchina te lo vede come sda?
> > magari la seconda volta e' sdb (o sdc o sdd :-D
>
> e perche` cavolo dovrebbe fare cosa si cretina? e il fstab allora a che
> serve?
>
aggiungo: infilato un cipollo usb (e provato a montarlo:
mount /mnt/usbthumb
mount: /dev/sda1 is not a valid block device
dmesg mi da:
hub.c: new USB device 00:1d.7-2, assigned address 10
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 10
sda: Unit Not Ready, sense:
Info fld=0xa00 (nonstd), Current 00:00: sense key Not Ready
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Info fld=0xa00 (nonstd), Current sd00:00: sense key Not Ready
sda : block size assumed to be 512 bytes, disk size 1GB.
sda: test WP failed, assume Write Enabled
/dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
sda: Unit Not Ready, sense:
Info fld=0xa00 (nonstd), Current 00:00: sense key Not Ready
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Info fld=0xa00 (nonstd), Current sd00:00: sense key Not Ready
sda : block size assumed to be 512 bytes, disk size 1GB.
sda: test WP failed, assume Write Enabled
/dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
Fede
|