Fabio Muzzi wrote:
Hello Mario,
Monday, October 18, 2004, 2:50:33 PM, you wrote:
particolare JB Weld (http://www.jbweld.net/) che ovviamente non riesco a
MP> E una colla epossidica bicomponente rapida
Cavolo, ma questa ti incolla la cerniera e amen. Piu` che una colla,
servirebbe un grasso densisssimo... che comunque non saprei dove trovare.
Il sito è esplicito!
incollo dal sito:
Ok, anyway, on to the repair. It turns out on my hinges, the friction
generating half of the hinge was still fine. On the other half of the
hinge, the round pin has a flat top, which is not supposed to turn
inside of the sleeve on the other side. However, it had ground out
enough of the sleeve that it could now turn freely in the sleeve. So ,
I went and got some JB Weld (or an equivalent epoxy) (which you can get
at nearly any hardware store very cheaply).
dice espressamente "JB Weld (or an equivalent epoxy)" e dice anche "the
friction generating half of the hinge was still fine" ovvero la cerniera
friziona bene (da sostenere lo schermo).
Roba usata dagli aeromodellisti. E' una colla strutturale che riempie le
fessure e fa spessore.
Da non mettere su una cerniera! Ma negli incavi delle alette laterali...
immagino.
Se la frizione della tua cerniera è insufficiente la soluzione, per me,
non e' quella indicata sul sito.
Ciao Mario
|